Human TIMP-1 Quantikine ELISA Kit Summary

Product Summary

The Quantikine Human TIMP-1 Immunoassay is a 3.5 hour solid phase ELISA designed to measure TIMP-1 concentrations in cell culture supernates, serum, plasma, and saliva. It contains NS0-expressed recombinant human TIMP-1 and antibodies raised against the recombinant factor. It has been shown to quantitate recombinant human TIMP-1 accurately. Results obtained using natural TIMP-1 showed linear curves that were parallel to the standard curve obtained using the Quantikine kit standards. These results indicate that this kit can be used to determine relative mass values for natural TIMP-1.

Preparation and Storage

Background: TIMP-1

TIMPs-1 through -4 regulate the activity of zinc metalloproteases known as MMPs, ADAMs and ADAMTSs. Structurally, TIMPs contain two domains. The N-terminal domain binds to the active site of mature metalloproteases via a 1:1 non-covalent interaction, blocking access of substrates to the catalytic site. In addition, The C-terminal domain of TIMP-1 and TIMP-2 binds to the hemopexin- like domain of pro-MMP-9 and pro-MMP-2, respectively. The latter binding is essential for the cell surface activation of MMP-2 by MMP-14.

Assay Procedure

Refer to the product datasheet for the complete assay procedure.

Bring all reagents and samples to room temperature before use. It is recommended that all samples, standards, and controls be assayed in duplicate.

1.     Prepare all reagents, standard dilutions, and samples as directed in the product insert.

2.     Remove excess microplate strips from the plate frame, return them to the foil pouch containing the desiccant pack, and reseal.

3.     Add 50 μL of Assay Diluent to each well.

4.     Add 50 μL of Standard, control, or sample to each well. Cover with a plate sealer, and incubate at room temperature for 2 hours.

5.     Aspirate each well and wash, repeating the process 4 times for a total of 5 washes.

6.     Add 100 μL of Conjugate to each well. Cover with a new plate sealer, and incubate at room temperature for 2 hours.

7.     Aspirate and wash 5 times.

8.     Add 100 μL Substrate Solution to each well.

9.     Add 100 μL of Stop Solution to each well. Read at 450 nm within 30 minutes. Set wavelength correction to 540 nm or 570 nm.