Human Serpin F1/PEDF DuoSet ELISA Summary

Product Summary

The Quantikine Human Osteopontin Immunoassay is a 4.5 hour solid-phase ELISA designed to measure human Osteopontin in cell culture supernates, plasma, urine, and human milk. It contains NS0-expressed recombinant human Osteopontin and has been shown to accurately quantitate the recombinant factor. Results obtained using natural human Osteopontin showed linear curves that were parallel to the standard curves obtained using the Quantikine kit standards. These results indicate that this kit can be used to determine relative mass values for naturally occurring human Osteopontin.

Preparation and Storage

Background: Osteopontin/OPN

Osteopontin (OPN), also known as bone sialoprotein (BSP), is a secreted SIBLING family protein that can be variably modified by O- and N-glycosylation, sulfation, phosphorylation, and transglutamination. OPN is widely expressed and is prominent in mineralized tissues. It inhibits bone mineralization and kidney stone formation and promotes inflammation, cell ad¬hesion, and migration. Its expression is upregulat¬ed during inflammation, obesity, atherosclerosis, cancer, and tissue damage and contributes to the pathophysiology of these conditions. The central region of OPN contains RGD and non-RGD binding sites for multiple integrins. Adjacent to the RGD motif is the sequence SLAYGLR (SVVYGLR in human) which serves as a cryptic binding site for additional integrins: it is masked in full length OPN but is exposed following OPN cleavage by multiple proteases in tumors and sites of tissue injury.

Assay Procedure

Refer to the product datasheet for the complete assay procedure.

Bring all reagents and samples to room temperature before use. It is recommended that all samples, standards, and controls be assayed in duplicate.

1.     Prepare all reagents, standard dilutions, and samples as directed in the product insert.

2.     Remove excess microplate strips from the plate frame, return them to the foil pouch containing the desiccant pack, and reseal.

3.     Add 50 μL of Assay Diluent to each well.

4.     Add 50 μL of Standard, control, or sample to each well. Cover with a plate sealer, and incubate at room temperature for 2 hours.

5.     Aspirate each well and wash, repeating the process 4 times for a total of 5 washes.

6.     Add 100 μL of Conjugate to each well. Cover with a new plate sealer, and incubate at room temperature for 2 hours.

7.     Aspirate and wash 5 times.

8.     Add 100 μL Substrate Solution to each well.

9.     Add 100 μL of Stop Solution to each well. Read at 450 nm within 30 minutes. Set wavelength correction to 540 nm or 570 nm.